Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Maebara, Sunao
JAERI-Research 2000-061, 104 Pages, 2001/01
JAERI-Research-2000-061.pdf:9.71MB
no abstracts in English
Maebara, Sunao; Goniche, M.*; Kazarian, F.*; Seki, Masami; Ikeda, Yoshitaka; Imai, Tsuyoshi; Bibet, P.*; Froissard, P.*; Rey, G.*
Fusion Engineering and Design, 49-50, p.269 - 273, 2000/11
Times Cited Count：4 Percentile：32.51(Nuclear Science & Technology)no abstracts in English
; ; ; Matsumoto, Shinichiro
JNC TN9410 2000-009, 65 Pages, 2000/09
JNC-TN9410-2000-009.pdf:4.36MB
In order to evaluate irradiation behavior of(U, Pu) C and (U, Pu) N fuel using fast reactor, (U, Pu) C and (U, Pu) N fuel pins were irradiated in JOYO for the fist time in Japan. In this study, one (U, Pu) C fuel pin and two (U, Pu) N fuel pins were irradiated to maximum burn up about 40GWd/t. Post irradiation examination of (U, Pu) C and (U, Pu) N fuel pins started in Fuel Monitoring Facility (FMF) at JNC from October 1999, and it ended in March, 2000. The results of non-destructive post irradiation examination reported in this document. Main results are shown in the following. (1)The soundness of all (U,Pu) C and (U,Pu) N fuel pins were confirmed from the non-destructive examination result. (2)The fuel stack elongation of (U,Pu) C and (U,Pu) N is bigger than it of the MOX fuel for fast reactor. (3)The singular behavior from the gamma ray scanning measurement in the stack area was not confirmed. The migration of Cs137 to lower insulator pellet and outside of the pellet was confirmed in (U,Pu) N B9NO2 pin. In (U,Pu) C fuel, the migration of Cs137 was not confirmed. (4)In (U,Pu) C B9CO1 pin and (U,Pu) N B9NO2 pin in which the gap width was small, diameter of cladding increase around 50 
m in the stack area which originates for FCMI was confirmed. In (U,Pu) N B9NO1 pin in which the gap width was wide, the ovality which originates from the relocation of the pellet was confirmed. (5)Fission gas release rate of (U,Pu) N were 3.3% and 5.2%, and the low value compared to the MOX fuel was shown.
; ;
JNC TN9400 2000-041, 29 Pages, 2000/03
JNC-TN9400-2000-041.pdf:1.18MB
Irradiation behavior and performance models were investigated in order to apply for nitride fuel options in feasibility study on fast breeder reactor and related recycle systems. (1)MechanicaI design of nitride fuel pin: The behaviors of fission gas release (increase of internal Pressure) and fuel-to-cladding chemical interaction (decrease of cladding thickness) are needed to evaluate cumulative damage fraction in case of fuel pin mechanical design. The behaviors of fission gas release and fuel-to-cladding chemical interaction were investigated from the past studies up to high burnuP, since the lower fission gas release in nitride fuel than in oxide fuel could contribute to reduce the plenum volume and result in the shortening of fuel Pin length. (2)Fuel pin smear density: The higher fuel smear density is preferred for the higher fissile density to improve the core characteristic. The behaviors of fuel pellet swelling were investigated from the past studies up to higher burnup, since the larger fuel pellet swelling in nitride fuel than in oxide fuel would restrict high burunp capability due to fuel-cladding mechanical interaction. (3)Compatibility of nitride fuel with high Temperature water: Compatibility of nitride fuel with high temperature water were investigated from the past studies to contribute water cooled fast breeder reactor options.
Sasajima, Hideo; Fuketa, Toyoshi; Nakamura, Takehiko; Nakamura, Jinichi; Uetsuka, Hiroshi; Kikuchi, Keiichi*; Abe, Tomoyuki*
JAERI-Research 99-060, p.62 - 0, 2000/03
JAERI-Research-99-060.pdf:12.05MB
no abstracts in English
Maebara, Sunao; ; Seki, Masami; Suganuma, Kazuaki; Ikeda, Yoshitaka; Imai, Tsuyoshi; Goniche, M.*; J.Brossaud*; V.Cano*; F.Kazarian-Vibert*; et al.
JAERI-Research 97-086, 29 Pages, 1997/11
JAERI-Research-97-086.pdf:1.33MB
no abstracts in English
Arai, Yasuo; Iwai, Takashi; ; Okamoto, Yoshihiro; Nakajima, Kunihisa; Niimi, Motoji; ; Yamahara, Takeshi;
JAERI-Research 95-008, 92 Pages, 1995/02
JAERI-Research-95-008.pdf:5.04MB
no abstracts in English
Arai, Yasuo; Iwai, Takashi; ; Nakajima, Kunihisa; ; ;
JAERI-Research 94-027, 66 Pages, 1994/11
JAERI-Research-94-027.pdf:4.09MB
no abstracts in English
Iwai, Takashi; Arai, Yasuo; Maeda, Atsushi; ; ; ;
JAERI-M 94-036, 81 Pages, 1994/03
no abstracts in English
; Saito, Hioraki*; *
Transactions of the 11th Int. Conf. on Structural Mechanics in Reactor Technology,Vol. C, p.1 - 6, 1991/08
no abstracts in English
; H.Devold*
Nihon Genshiryoku Gakkai-Shi, 28(8), p.771 - 782, 1986/00
Times Cited Count：2 Percentile：32.46(Nuclear Science & Technology)no abstracts in English
